, which contains both flex and curve controls, and select the camera view.< Previous | Contents | Manuals Home | Boris FX | Next >
Once you have identified the section of curve to be tracked and made into a 3-D flex, you should open the Flex Control Panel
, which contains both flex and curve controls, and select the camera view.
Click the New Curve button, then, in the Camera View, click along the section of curve to be tracked, creating control points as you go. Place additional control points in areas of rapid curvature, and at extremal points of the curve. Avoid area where there is no trackable edge if possible.
When you have finished with the last control point, right-click to exit the curve creation mode.
©2024 Boris FX, Inc. — UNOFFICIAL — Converted from original PDF.