www.ssontech.com

[agrapha]

we have a low track across the surface of our set, and seemingly have a great solve in SNI. Wireframe, grids, all seem to be working correctly. We use the points generated at the edge, and extrude them to create the set extension. All seems fine until renders come out.

All the objects are travelling too quickly at the seam line, as if they were a lot closer than they should be. Scaling the rendered shot down to 75% on the horizontal gives the correct speed across frame, as does scaling the width and depth component of the solved set pieces to 150% and rendering normally.

Our lens is a known lens, and all points derived within SNI.

Any ideas?